class-map match-any class-voice description Voice match dscp af11 match dscp cs4 match dscp cs3 ! policy-map qos-out class class-voice priority 100 ! interface Tunnel1 description Tunnel to VOIP Server ip address 10.10.0.2 255.255.255.252 tunnel source FastEthernet0/1 tunnel destination 172.16.100.100 tunnel mode ipip ! interface FastEthernet0
tunnel select 1 ipsec tunnel 101 ipsec sa policy 101 1 esp 3des-cbc md5-hmac anti-replay-check=off (※2) ipsec ike keepalive use 1 on ipsec ike local address 1 172.16.1.1 ipsec ike pre-shared-key 1 text (パスワード) ipsec ike remote address 1 (固定IPアドレス2) queue tunnel class filter list 4 5 6 tunnel enable 1 tunnel select 2 Optimizing Bandwidth Between Sonicwall Site-to-Site VPN Nov 30, 2012 DMVPN Per-Tunnel QoS - NetworkLessons.com To demonstrate DMVPN Per-Tunnel QoS I will use the following topology: Above we have a hub and four spoke routers. Let’s imagine that the spoke1 and spoke2 routers are connected using a 5 Mbps link, the spoke3 and spoke4 routers are using a slower 1 Mbps link. 802.1p and DSCP QoS
For clear text traffic, the default profile applies to all clear text traffic as an aggregate. For tunneled traffic, the default profile is applied individually to each tunnel that does not have a specific profile assignment in the detailed configuration section. For instructions on defining QoS profiles, refer to Network > Network Profiles > QoS.
Hi all, I need some help with setting up QoS for VoIP between two Cisco ASA 5505 with Site-to-Site VPN. There is no need for bandwith reservation, only DSCP 46 (EF) should be highest and DSCP 26 second highest queue and the rules should only apply to a site-to-site VPN.
If a traffic shaping rule is defined on a Cisco Meraki MX Security Appliance to include a DSCP tag, the DSCP tag will remain in the IP packet as it traverses the VPN tunnel to the remote end. This is because DSCP exists at layer 3 and as such is routed from network to network.
Mar 19, 2019 Enable QoS Marking for a Managed BOVPN Tunnel Enable QoS Marking for a Managed BOVPN Tunnel. To use QoS with a managed BOVPN tunnel, you must create a VPN firewall policy template and apply that template to the managed BOVPN tunnel. You cannot edit the default Any policy for managed BOVPN tunnels.